Hi folks,
I really like the possibility to move to the defined endpoint and to the start point again which is possible with the zerene stackshot panel.
But, I always prefere to touch hardware buttons rather to turn virtual knobs on my laptop.
I think there is a special button combination on stackshot controller, which is doing the same. I searched the cognisys hp, but I can not find any documentation. I beleive to remembre, to have seen this feature integrated in a firmware update.
Do anyone know anything about this feature?
Thanks for any answer
Antal
Stackshot controller: How to move to endpoint
Moderators: rjlittlefield, ChrisR, Chris S., Pau
-
- Posts: 1511
- Joined: Mon Jan 15, 2018 9:23 pm
- Contact:
Re: Stackshot controller: How to move to endpoint
Why not ask their customer support team? They have always been responsive and helpful.
Re: Stackshot controller: How to move to endpoint
Here is the answer by Paul from Cognisys:
Pressing CONFIG+UP buttons takes a shot at the first and last shot of a stack.
It can be found in the release notes of a firmware update:
https://cognisys-inc.com/downloads/stac ... 1_0_09.pdf
Pressing CONFIG+UP buttons takes a shot at the first and last shot of a stack.
It can be found in the release notes of a firmware update:
https://cognisys-inc.com/downloads/stac ... 1_0_09.pdf